New cnc user software issues. (using cut2d with 6040z)

Re: New cnc user software issues. (using cut2d with 6040z)

Postby dwilli9013 » Mon Feb 20, 2017 10:06 pm

Your rapid feed rate may be set to high as well. If the move consists of both the x and y axis having to move at the same time the inertia may be a bit too much.
D-Dub
Dwayne
Dwilli
User avatar
dwilli9013
Vectric Wizard
 
Posts: 831
Joined: Mon Sep 30, 2013 12:45 am
Location: Machesney Park Illinois
Model of CNC Machine: 3 axis Self Designed Self Built

Re: New cnc user software issues. (using cut2d with 6040z)

Postby Leo » Tue Feb 21, 2017 12:00 am

Video is great - helps a LOT.

The noise when the machine hangs up is losing steps.

I think you may need to adjust the accel and decell. That is the speed that the axis ramps up and ramps down as it changes direction. If is tries to get up to speed too fast is chatters and hangs up. It that time it looses steps then everything is out to lunch.

You may also want to be sure that all the slides are running freely and smoothly. You don't want anything too loose either.

Some lubricant certainly doesn't hurt either.
Imagine the Possibilities of a Creative mind

www.leosworkshop.com
User avatar
Leo
Vectric Wizard
 
Posts: 2418
Joined: Sat Jul 14, 2007 3:02 am
Location: East Freetown, Ma.
Model of CNC Machine: 1300 x 1300 x 254

Previous

Return to Control Software related questions

Who is online

Users browsing this forum: No registered users and 1 guest