Or are you saying that you changing the start position on the vector doesn't change the way the toolpath runs?
play with whatever control software you're using
jackson74 wrote:Does anyone know why I am getting those huge radius corners when using a .25" 60 degree v bit with a cut depth of .06?
The preview shows tight square corners but then the machine with these huge radius like I am using a .5" endmill?
If it's not doing what V-Carve says it's doing, then it's most likely your machine settings. When you worked on fixing the ballscrew did you play with whatever control software you're using, maybe during calibration? Maybe you changed the error % allowed, or flipped between "Constant Velocity" and "exact" or some other obscure box got checked. Do you have a test program on your controller itself, not created by V-Carve, that you can test?
Users browsing this forum: No registered users and 5 guests