Return to point after accidentally hitting e-srop

Post Reply
jdsmith1000
Posts: 10
Joined: Thu Dec 03, 2015 4:34 pm
Model of CNC Machine: Shark HD 3

Return to point after accidentally hitting e-srop

Post by jdsmith1000 »

I'm running my shark HD3 and accidentally hit e-stop. Please don't ask how, just did. How do I return to the point where the machine was when I hit the e-stop? Thanks, James

Frunple

Re: Return to point after accidentally hitting e-srop

Post by Frunple »

The machine should stop when you hit the Estop. Are you sure you have it wired correctly?

User avatar
FixitMike
Vectric Wizard
Posts: 2173
Joined: Sun Apr 17, 2011 5:21 am
Model of CNC Machine: Shark Pro Plus (retired)
Location: Burien, WA USA

Re: Return to point after accidentally hitting e-srop

Post by FixitMike »

Which E-stop did you hit? Did you click on the one one the screen or the push the button on the controller? If it was the button on the controller, it cut power to the controller and you are out of luck. I've not used the E-stop on the screen.

I don't believe there is a way to return to where you were with the Shark controller. However, if you know the line number it stopped on, you can edit the G-code to remove the moves before it, rezero, and then run the new program. Probably easiest to add the wood to the fireplace pile and start over.
Good judgement comes from experience.
Experience comes from bad judgement.

Post Reply