vcarve and gravograph is800

[Scratchpro]

Hi,

I have a gravograph is800 machine running with engravelab but I want to use vcarve. I have read a few posts and seems it can be done, the machine is running the 2.4 firmware and I wondering if it will drive my gravograph.

I have downloaded the trial and there is some gravograph machines listed to send the job to but the is800 isn't listed, the is600 is though.

I believe the is600 has the same control box so maybe it could send it to the is600?

Any ideas on this? We have a few is800 machines and would like run them all on vcarve if possible

Thanks