Problem with curves

Post Reply
studysession
Vectric Wizard
Posts: 473
Joined: Tue Sep 04, 2007 11:45 am
Model of CNC Machine: DIY
Location: Maryland, USA
Contact:

Problem with curves

Post by studysession »

My machine for some reason is messing up. I upgraded to VCarve 5.0. Attacheed is my file without the machine code to make it smaller. I am using Mach3 latest stable build.

Everything was fine then one day any curve is a weavy curve instead of a normal rounded curve.

Anyone have any advice?

Thanks
Attachments
Wedding-Book-Test-001.crv
(119.5 KiB) Downloaded 199 times
http://www.makemyownguitar.com
http://www.cncinside.com

User avatar
Adrian
Vectric Archimage
Posts: 14543
Joined: Thu Nov 23, 2006 2:19 pm
Model of CNC Machine: ShopBot PRS Alpha 96x48
Location: Surrey, UK

Re: Problem with curves

Post by Adrian »

If you're using Mach3 then try changing the IJ Mode to Inc instead of Absolute within the Mach3 Config>General Config menu.

I think VCarve 5 uses the Arcs post processors by default so you may not have seen this problem with the previous version.

Post Reply