Lately the Draw Tool check box has been checked whenever I open a project. I assumed it got checked by accident, since I don't often use it. Today, I turned it off and reloaded the project... and it was back on. I tried saving the project, unchecking both boxes, and checking the Options. I have 'Animate Cursor Moves' set to NO. I even reset my Options. Still, every time I load a project, the checks are back on. Normally I only keep 'Animate Preview' on. Aspire v10.018. What am I missing? Am I going nuts (debatable)?
Draw Tool Problem
- TReischl
- Vectric Wizard
- Posts: 4653
- Joined: Thu Jan 18, 2007 6:04 pm
- Model of CNC Machine: 8020 48X36X7 RP 2022 UCCNC Screenset
- Location: Leland NC
Re: Draw Tool Problem
For that particular file:
Open it
Change settings
Save.
For future files:
New file
change settings
Save and exit
That should work IIRC. We are all nuts to one degree or another. . . . . .
Open it
Change settings
Save.
For future files:
New file
change settings
Save and exit
That should work IIRC. We are all nuts to one degree or another. . . . . .
"If you see a good fight, get in it." Dr. Vernon Johns
- gkas
- Vectric Wizard
- Posts: 1451
- Joined: Sun Jan 01, 2017 3:39 am
- Model of CNC Machine: Aspire, Axiom AR8 Pro+, Axiom 4.2W Laser
- Location: Southern California
Re: Draw Tool Problem
I had tried both those... neither worked. I reset my options, and restarted Aspire umpteen times. No change. I can change the checks, save, close, and reopen, and BOTH checks are back.TReischl wrote:For that particular file:
Open it
Change settings
Save.
For future files:
New file
change settings
Save and exit
That should work IIRC. We are all nuts to one degree or another. . . . . .
- gkas
- Vectric Wizard
- Posts: 1451
- Joined: Sun Jan 01, 2017 3:39 am
- Model of CNC Machine: Aspire, Axiom AR8 Pro+, Axiom 4.2W Laser
- Location: Southern California
Re: Draw Tool Problem
I just figured out the answer. If you close the Preview Toolpaths dialog BEFORE YOU SAVE AND EXIT THE FILE, everything works correctly. I don't remember having to do that.... but hey, it works.
- TReischl
- Vectric Wizard
- Posts: 4653
- Joined: Thu Jan 18, 2007 6:04 pm
- Model of CNC Machine: 8020 48X36X7 RP 2022 UCCNC Screenset
- Location: Leland NC
Re: Draw Tool Problem
Well that is pretty strange, I do not recall ever having to do that either. Hmmmph.
"If you see a good fight, get in it." Dr. Vernon Johns
- Adrian
- Vectric Archimage
- Posts: 14660
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Draw Tool Problem
Just checked through the VCarve versions I have and 9 behaves the same way but 7 doesn't, I don't have 8 installed to try that. Guess the settings are only saved on dialog exit since 8 or 9.