Auto Switch for the DC

Auto Switch for the DC

Postby SteveNelson46 » Mon May 27, 2019 6:11 pm

I just installed an iVac pro switch system on my Stinger to control the DC. It's RF remote attaches to the outside of the power cord of the spindle. When it senses current flow it sends a signal to the switch to turn the DC on. When the power to the spindle stops the remote sends a signal to power off the DC. The 2hp DC pulls about 20 amps so I had to put a contactor relay switch inline to handle the current draw. The system is completely non-invasive and requires no integral hookup to the machine. So far, it seems to work really good.
Steve
User avatar
SteveNelson46
Vectric Wizard
 
Posts: 486
Joined: Wed Jan 04, 2012 2:43 pm
Location: Tucson, Az.
Model of CNC Machine: Camaster Stinger with Recoil Lathe

Re: Auto Switch for the DC

Postby TReischl » Wed May 29, 2019 1:51 pm

That is what is commonly referred to as: STYLIN'
http://www.tedreischl.com

Low Profile CNC Router Vise
User avatar
TReischl
Vectric Wizard
 
Posts: 2714
Joined: Thu Jan 18, 2007 6:04 pm
Location: Leland NC
Model of CNC Machine: 8020 Build 48X36X10 RP 2010 Screenset


Return to Hardware related questions

Who is online

Users browsing this forum: No registered users and 1 guest