I have a Laguna iq.
I'm getting power to my HHC but nothing else. Like it wont boot up. Just a blank screen. anyone have any suggestions??
I checked all my fuses and they are all good . Pin connector is good with no damage ..
Laguna IQ hhc problem
-
- Posts: 18
- Joined: Sun Mar 11, 2018 3:35 am
- Model of CNC Machine: LAGUNA IQ
-
- Vectric Craftsman
- Posts: 253
- Joined: Fri May 09, 2014 1:37 pm
- Model of CNC Machine: Laguna IQ
- Location: Pensacola FL
Re: Laguna IQ hhc problem
Did you check to see if the emergency stop button accidentally got pressed in? Try twisting clockwise to see if it pops out.
-
- Posts: 18
- Joined: Sun Mar 11, 2018 3:35 am
- Model of CNC Machine: LAGUNA IQ
Re: Laguna IQ hhc problem
Yes I have checked it. I pushed it in and turned it out several times . I've rebooted it several times. Unplugged it for a hour and turned it back on. Still same problem
-
- Vectric Craftsman
- Posts: 253
- Joined: Fri May 09, 2014 1:37 pm
- Model of CNC Machine: Laguna IQ
- Location: Pensacola FL
Re: Laguna IQ hhc problem
And then pressed (again) the green start button?