Laguna IQ hhc problem

Laguna IQ hhc problem

Postby PATRICKCUES » Sun May 26, 2019 9:38 am

I have a Laguna iq.
I'm getting power to my HHC but nothing else. Like it wont boot up. Just a blank screen. anyone have any suggestions??
I checked all my fuses and they are all good . Pin connector is good with no damage ..
PATRICKCUES
 
Posts: 16
Joined: Sun Mar 11, 2018 3:35 am
Model of CNC Machine: LAGUNA IQ

Re: Laguna IQ hhc problem

Postby litzluth » Sun May 26, 2019 1:49 pm

Did you check to see if the emergency stop button accidentally got pressed in? Try twisting clockwise to see if it pops out.
litzluth
Vectric Apprentice
 
Posts: 94
Joined: Fri May 09, 2014 1:37 pm
Model of CNC Machine: Laguna IQ

Re: Laguna IQ hhc problem

Postby PATRICKCUES » Tue May 28, 2019 8:16 am

Yes I have checked it. I pushed it in and turned it out several times . I've rebooted it several times. Unplugged it for a hour and turned it back on. Still same problem
PATRICKCUES
 
Posts: 16
Joined: Sun Mar 11, 2018 3:35 am
Model of CNC Machine: LAGUNA IQ

Re: Laguna IQ hhc problem

Postby litzluth » Tue May 28, 2019 1:44 pm

And then pressed (again) the green start button?
litzluth
Vectric Apprentice
 
Posts: 94
Joined: Fri May 09, 2014 1:37 pm
Model of CNC Machine: Laguna IQ


Return to Hardware related questions

Who is online

Users browsing this forum: No registered users and 2 guests