Today's Lesson

Today's Lesson

Postby Rcnewcomb » Mon May 20, 2019 1:29 am

It is important to learn something new each and every day.

Today I learned that if my Automated Tool Changer (ATC) isn't properly adjusted the tool holder slips out of the spindle as it is spinning up to speed. Those tool holders behave just like heavy metallic tops spinning at 12K RPM and it takes a surprisingly long time for them to slow down. Fortunately the only damage was a broken bit. Had my head been in the line of fire, however, I would likely not be posting this entry today.

Check your tools regularly.
- Randall Newcomb
User avatar
Rcnewcomb
Vectric Wizard
 
Posts: 3544
Joined: Fri Nov 04, 2005 5:54 am
Location: San Jose, California, USA
Model of CNC Machine: GCnC/WinCNC

Re: Today's Lesson

Postby jimwill2 » Mon May 20, 2019 1:39 am

Wow! Glad you weren't injured.
Jim Williams
jimwill2
Vectric Wizard
 
Posts: 583
Joined: Tue Aug 31, 2010 1:48 am
Location: Superior, Colorado
Model of CNC Machine: CaMaster Stinger w/recoil, FTC

Re: Today's Lesson

Postby ger21 » Mon May 20, 2019 2:04 am

The spindle should have a sensor to make sure that the tool is engaged before it ever starts spinning.
Gerry - http://www.thecncwoodworker.com
ger21
Vectric Wizard
 
Posts: 1478
Joined: Sun Sep 16, 2007 2:59 pm
Location: Shelby Township, MI, USA
Model of CNC Machine: Custom DIY

Re: Today's Lesson

Postby garylmast » Mon May 20, 2019 4:12 pm

On my last project, although I don't have an automatic tool changer, a similar situation happened. I was using a 1/2 mill and it came out of the collet and flung to the side of the CNC. I was just lucky it didn't hit me. At first I thought I forgot to tighten the nut, but then it happened again, but not completely flying out. Now thinking it was the collet, it continued to slip out after changing it. It turned out that the nut, by going to deep and riding against the material got hot and weakened the snap spring that holds the collet in place...it wouldn't clamp tight enough to hold the mill tight. I replaced the nut and how everything is tight again.

Gary
garylmast
Vectric Wizard
 
Posts: 973
Joined: Fri Oct 23, 2009 4:03 pm
Location: Sandy, Utah

Re: Today's Lesson

Postby highpockets » Mon May 20, 2019 5:32 pm

Every once and a while we need a wake up call as to the true power and dangers of these machines. Glad you weren't hurt. I would have had to change my shorts.
John
Maker of Chips
User avatar
highpockets
Vectric Wizard
 
Posts: 2400
Joined: Tue Jan 06, 2015 4:04 pm
Model of CNC Machine: PDJ Pilot Pro


Return to Hardware related questions

Who is online

Users browsing this forum: No registered users and 6 guests