Hello. I downloaded the control panel and run an air cut from my laptop, it looks as if it is cutting correctly. So as suggested by Adrian, the file I sent to Vectric support was from my laptop and not the flashdrive, which does explain why they did not see anything wrong. So I can cut direct from my laptop for now. But I plan on getting a new flashdrive, because I would prefer that method. I know I ejected the flashdrive correctly, but something went wrong, the "file was truncated" somehow. Hopefully a new flashdrive will fix the problem.
What I don't understand though LittleGreyMan states the pendant shows the right file size, but Less Lines than the g code file. How can the file size be the same, but have less g code lines, shouldn't that shrink the file size? That's what I was looking at when the problem began. The tap file size on my computer was the same size as the tap file on the pendant. I thought if anything was missing the file sizes would be different. What GB flashdrive should I be using? Is there a specific brand flashdrive I should be using? And one last question, I have heard that some programs don't respond correctly to Windows 10, has anyone had similar issues when using Windows10?
Thank you everybody for your advice!!! I am so glad I can start cutting, I just would prefer using a falshdrive rather than running direct from my laptop. Thanks again everyone!