First test run

First test run

Postby Gunny Rogers » Tue Aug 07, 2018 2:08 am

Ran my CNC Piranha for the first time. Confused: When the machine started running, instead of starting at 0.0:0.0 on the bed it started in the lower right quadrant. Is that normal or how do I correct it to the center of the bed?
Gunny Rogers
 
Posts: 20
Joined: Sat Aug 22, 2015 1:41 am
Model of CNC Machine: 141001

Re: First test run

Postby Adrian » Tue Aug 07, 2018 9:27 am

Where did you define the XY zero in the job setup?
User avatar
Adrian
Vectric Archimage
 
Posts: 8591
Joined: Thu Nov 23, 2006 2:19 pm
Location: Surrey, UK
Model of CNC Machine: ShopBot PRS Alpha 96x48

Re: First test run

Postby Gunny Rogers » Tue Aug 14, 2018 1:49 am

Thanks for the reply. I discovered that I was supposed to designate my 0:0,0:0 prior to turning on the machine. This is a learning experience after all.
Gunny Rogers
 
Posts: 20
Joined: Sat Aug 22, 2015 1:41 am
Model of CNC Machine: 141001


Return to Hardware related questions

Who is online

Users browsing this forum: Exabot [Bot] and 5 guests