I am trying to add an image so there is clarification of what I am discussing, why can't I?
- Posts: 16
- Joined: Thu Jan 19, 2017 5:15 pm
- Model of CNC Machine: Shark HD4
I just had the same problem a few minutes ago. I recreated the .png file and tried again. It worked but I'm not sure that what I did was the fix. Both files were under 1 meg.
- Vectric Wizard
- Posts: 622
- Joined: Wed Jan 04, 2012 2:43 pm
- Location: Tucson, Az.
- Model of CNC Machine: Camaster Stinger using WinCNC
Return to Hardware related questions
Who is online
Users browsing this forum: No registered users and 6 guests