Anyone using Rich Auto HHC?
I received a new controller because one of the buttons on the old one didn't work.
Rich Auto-Auto Now-A11E.
I copied all the settings over from the old one.
I can do everything but start the spindle On/Off .
I can't run a file neither.
I load the file, it tells me the file name, I click OK.
I get the number of lines etc.
I click OK.
It goes back to View File etc.
I am using Laguna IQ HHC (mm)(*.mmg) as the pp.
There is no ID required.
It worked on the old controller, why not on the new one?
Cut3D, VCarvePro 6.5, Aspire4, PhotoVCarve, Corel Graphics Suite X6