Rich/Laguna Hand Held Controller

Post Reply
User avatar
Ms Wolffie
Vectric Wizard
Posts: 2695
Joined: Sat Mar 31, 2012 10:41 pm
Model of CNC Machine: Blue Elephant 1325, Shark HD Pro
Location: Tully Heads, Wet Tropics, Queensland, Australia

Rich/Laguna Hand Held Controller

Post by Ms Wolffie »

Anyone using the Rich/Laguna Hand Held Controller?
I have finally managed to get the X and Y 0.000 right but I cannot get the Z to behave itself.
I home all switches then press Menu + Mode and XY are good but Z is any old number.
I click down to 1Z, press Delete, set the numbers to 0.000. press OK and all Axes are 0.00
I press Mode + Z0/8 to fix the numbers.
I then press Origin/OK and the spindle starts shooting down with the numbers going positive.
I press Z+/3 to get it back, it goes up slowly but the numbers keep on going positive so, if I stopped at 40.3 it will then read 80.6 when I get back to the switch.
I just cannot get it right.
Cheers
Wolffie

Whatshammacallit
Cut3D, VCarvePro 6.5, Aspire4, PhotoVCarve, Corel Graphics Suite X6

User avatar
Ms Wolffie
Vectric Wizard
Posts: 2695
Joined: Sat Mar 31, 2012 10:41 pm
Model of CNC Machine: Blue Elephant 1325, Shark HD Pro
Location: Tully Heads, Wet Tropics, Queensland, Australia

Re: Rich/Laguna Hand Held Controller

Post by Ms Wolffie »

I think I finally got it.
The home switches have to be X and Y - and Z+
Phew, maybe I can start working now.
Cheers
Wolffie

Whatshammacallit
Cut3D, VCarvePro 6.5, Aspire4, PhotoVCarve, Corel Graphics Suite X6

Post Reply