Dclifton2 wrote:Anytime, if I'm not home just leave a message and I will call you back. I'm retired so I'm home most of the time.
sebashtionh wrote:Hello, I hope this is the right forum to ask this. I Ordered my CNC Router and have never used one. Are there training DVDs/Videos for how to operate one safely? Training on job set up, Speeds and feeds, Where to start with bit selection, I am going to do 3d carvings, V carvings, cutting out templates for my woodworking, Logos In Wood..... pretty much a welcome to cnc routing.... please remember I have never used one, I have 23 years in custom cabinets and High end Furniture, so not new to tools just CNC Routers.
I have been going thru the Aspire Tutorials ( this is the software I bought waiting for it to come in) and still have a lot to learn but where to go from design, to tool paths, to???
thanks in advance for your help
Users browsing this forum: No registered users and 3 guests