Working in VCarve
-
- Posts: 4
- Joined: Mon May 07, 2012 6:39 pm
- Model of CNC Machine: shark cnc hd pro plus extended
- Location: Blaine, MN. USA
Working in VCarve
Working in VCarve Pro I imported a 3D model onto my work surface. When I move the model to where I want it on the work surface and preview the toolpaths, the model is shown in the original position that it was in when imported, not at the position I had moved it to. Is there something I'm missing?
- Leo
- Vectric Wizard
- Posts: 4091
- Joined: Sat Jul 14, 2007 3:02 am
- Model of CNC Machine: 1300 x 1300 x 254 Chinese Made
- Location: East Freetown, Ma.
- Contact:
Re: Working in VCarve
Did you recalculate the tool path?
Imagine the Possibilities of a Creative mind, combined with the functionality of CNC
-
- Posts: 4
- Joined: Mon May 07, 2012 6:39 pm
- Model of CNC Machine: shark cnc hd pro plus extended
- Location: Blaine, MN. USA
Re: Working in VCarve
Just tried that too, no change.
- Adrian
- Vectric Archimage
- Posts: 14680
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Working in VCarve
Are you importing an actual 3D model (STL, V3M, SKP etc) or a calculated toolpath file from Cut3D or Vector Art Machinist?
-
- Posts: 4
- Joined: Mon May 07, 2012 6:39 pm
- Model of CNC Machine: shark cnc hd pro plus extended
- Location: Blaine, MN. USA
Re: Working in VCarve
I see that using the actual 3d model it works fine. The question still remains the same when imported from Vector Art machinist or Cut3d, it doesn't seem to work. Any solutions.