cnc3020 motor tuning

Post Reply
Giggins
Posts: 7
Joined: Thu Jan 08, 2015 2:40 am
Model of CNC Machine: mini-cnc engraving machines 3axis 2030

cnc3020 motor tuning

Post by Giggins »

hi i am heaving problem. withe my mach3 it is my config motor tuning it runs good in
diagnostics. but not in program run . i have gone in to my motor tuning tread to set all
motor to the right speed what am i doing wrong. thank you

User avatar
martin54
Vectric Archimage
Posts: 7339
Joined: Fri Nov 09, 2012 2:12 pm
Model of CNC Machine: Gerber 48, Triac PC, Isel fixed gantry
Location: Kirkcaldy, Scotland

Re: cnc3020 motor tuning

Post by martin54 »

Have you watched the mach3 tutorials on setting up? You can find them on the mach support site. Not familiar with your machine so no point me giving you my settings but after you have set up the steps per revolution then in motor tuning you will need to play around with velocity & acceleration settings yourself, once you have a point where it is running without stalling the motors back the settings off by about 10% before saving the settings for each axis.
There is also quite a lot of help available on the mach forum, I would suggest you register with that forum as well.

Post Reply