Spindle Question

Post Reply
angelkarla
Vectric Apprentice
Posts: 55
Joined: Tue May 03, 2011 8:28 am
Model of CNC Machine: home made
Location: Barmouth UK
Contact:

Spindle Question

Post by angelkarla »

Hi I Have a 2.2kw spindle and DZB200 vdf. I have fitted a new breakout board to machine which has a digital switch instead of 0-10 volts output for operating spindle. I am using mach 3 software.
Can anyone tell me the two connections inside vdf to make spindle run please. :(
Please feel free to move post if its in wrong place
If all else fails read the instructions

armbrusterco
Vectric Craftsman
Posts: 128
Joined: Tue Feb 14, 2012 5:26 am
Model of CNC Machine: Roland MDX-40A
Location: Lake Barrington, IL
Contact:

Re: Spindle Question

Post by armbrusterco »

You might try posting the question on the CNCzone forum. Someone there might have similar equipment. My spindle and VFD is different than yours so I can't help.
Bob Armbruster
www.ArmbrusterCo.com

dan_barber
Posts: 14
Joined: Wed May 13, 2009 4:06 pm

Re: Spindle Question

Post by dan_barber »

I have not worked with DZB200 drives.

I've done something similar with a FUJI FRENIC MEGA drives. Check out Fuji's manual.

http://www.ctiautomation.net/PDF/FUJI/F ... -Guide.pdf

Post Reply