etgrthrx wrote:So it goes something like this: I've recently become employed as a CNC Operator for a Hotel, and I've been learning as I go along--the only reason I was hired is because I am the only one who is somewhat computer literate. I got the whole Vcarve stuff down quite well and have created a lot of signage, but when it comes to the CNC machine itself I am a amatuer. My question: are there any web sites or books that will help me understand? Also, I'm working with a Laguna IQ Pro B&R CNC, and the manual that came with it isn't that great on detail.
I'm pretty sure if I'm adjusting the TEACH TOOL LENGTH every so often so that the v-bit will at least touch the spoil board I might not being operating it properly.
Any advice would be much appreciated, thanks.
Users browsing this forum: No registered users and 3 guests