KWiK wrote:Thanks Mike.
So Basically I was correct in that the Base Flat Depth - Inlay Start Depth, gives you the space between the two. So the PDF example in Post 1 has a Base Flat Depth of 0.3" and a Inlay Start Depth of 0.1", so that would give you 0.3" - 0.1" = 0.2" of glue gap? Doesn't that seem excessive? I would think a gap of 0.05" to 0.1" would be more than enough?
Do people always use Inlay Start Depth + Inlay Flat Depth = Base Flat Depth?
FixitMike wrote:In my personal opinion, those settings are in error. I vary the settings depending upon the material, inlay details, and how I intend to remove the excess material (and sometimes how I feel, or what day of the week it is.). Almost always I set the base flat depth to be about .03" greater than the inlay start depth.
Just be very to sure to remove all of the fuzzies and splinters from the pieces before you put them together. I use a toothbrush and dental picks.
Users browsing this forum: No registered users and 5 guests