is there a guide as to what the pass depth should be in comparison to the tool's diameter?
Yabba wrote:Well, the offsets were not the issue... they were all set to 0. I did see a couple of other things though. There were only 8 tools listed in the pendant, and I use tools numbered up to 13 - I added 5 more. After speaking with Cancam again, they told me to change the distance that the spindle rises after setting z to zero... it defaults to .389, I changed it to .1 - he recommended doing this due to the fact that my machine does not have great z travel, and with my spoilboard and material both being 11/16", there was not much room left for the spindle to rise after using the calibration tool for z. I have yet to re try the project, I'll post results.
Users browsing this forum: No registered users and 5 guests