adding vectors to clip art
-
- Posts: 15
- Joined: Mon Oct 15, 2018 11:07 pm
- Model of CNC Machine: Camaster Stinger III
adding vectors to clip art
I'd like to add the window pane vectors to the bottom side of the clip art as shown on attached picture to add support for the flower pedals as I'd like to cut through and use this as a door window cover. Any guidance?
-
- Posts: 15
- Joined: Mon Oct 15, 2018 11:07 pm
- Model of CNC Machine: Camaster Stinger III
Re: adding vectors to clip art
I use Vcarve Pro version 9.5
- FixitMike
- Vectric Wizard
- Posts: 2177
- Joined: Sun Apr 17, 2011 5:21 am
- Model of CNC Machine: Shark Pro Plus (retired)
- Location: Burien, WA USA
Re: adding vectors to clip art
There are 3D tabs in the Clipart that you could add (merge) with the file.
Good judgement comes from experience.
Experience comes from bad judgement.
Experience comes from bad judgement.
-
- Posts: 15
- Joined: Mon Oct 15, 2018 11:07 pm
- Model of CNC Machine: Camaster Stinger III
Re: adding vectors to clip art
Awesome Mike. This is my firs post. Thanks for advice. I'll work on that tomorrow. I'm sure my next question will be how to assign which item is on top???
-
- Posts: 15
- Joined: Mon Oct 15, 2018 11:07 pm
- Model of CNC Machine: Camaster Stinger III
Re: adding vectors to clip art
I've had softwarer/machine 6 months. I'm green!
- FixitMike
- Vectric Wizard
- Posts: 2177
- Joined: Sun Apr 17, 2011 5:21 am
- Model of CNC Machine: Shark Pro Plus (retired)
- Location: Burien, WA USA
Re: adding vectors to clip art
Best to watch a couple of applicable tutorials. Pick them from here: https://support.vectric.com/tutorials/V ... =1&order=1
Good judgement comes from experience.
Experience comes from bad judgement.
Experience comes from bad judgement.