Stacked Text Tool Change Question
Posted: Tue Jul 31, 2018 7:12 am
I'm trying to wrap my head around this one, my friends! Watching the Tutorial on Stacked Text, he states that he uses the Flat Area Clearance Tool (EM .25"), but since they never share how the tool paths are saved, or a video on how they are incorporated with the 60 deg V-Bit, I just have no clue as to the proper steps to take to ensure that I do not come out with a flaw (or worse off, damaged goods!).
Can someone take my hand and either lead me to where I can read up on Stacked Text, or point me to a video that someone has made explaining the tool changes.
My puzzlement deals with this... if there were no double tools with each level of the project, then one can group the Engraving Toolpaths together, and have a separate path for the Profile Cut at the end with the .25" EM.
I hope you are able to understand my bewilderment, and I do look forward from someone in the community to lead me on the right path to doing Stacked Text Signs!
Thanks to everyone in advance.
Can someone take my hand and either lead me to where I can read up on Stacked Text, or point me to a video that someone has made explaining the tool changes.
My puzzlement deals with this... if there were no double tools with each level of the project, then one can group the Engraving Toolpaths together, and have a separate path for the Profile Cut at the end with the .25" EM.
I hope you are able to understand my bewilderment, and I do look forward from someone in the community to lead me on the right path to doing Stacked Text Signs!
Thanks to everyone in advance.