Page 1 of 1

Finishing textured hardwood surfaces?

PostPosted: Tue Jun 12, 2018 8:23 pm
by dtorney
I've made bowls of ~1000 overlapping flattened spheres, 2 1/2 inches on the long diameters and 3/4 inch
on the short diameter. So, surfaces are textured with about 1/4" variation in height.

I'd like to learn an efficient way to smooth the crevices: where two spheres meet. The best I've found
is New Wave scuff & buff balls, like an abrasive scrub pad attaching to a drill. Sandblasting seems a good
idea.

Re: Finishing textured hardwood surfaces?

PostPosted: Tue Jun 12, 2018 10:36 pm
by mtylerfl
Hi David,

Please show us a photo or two of what you're talking about. (Pics of the project not the puff balls.)