Page 1 of 1
3D relief, Mini Book
Posted: Mon May 21, 2018 5:03 am
by creativescrollworks
Any tutorials for doing the 3D relief mini book?
Also adjusting text for the curve of the book.
Thanks
Re: 3D relief, Mini Book
Posted: Mon May 21, 2018 8:43 am
by Adrian
Re: 3D relief, Mini Book
Posted: Mon May 21, 2018 7:56 pm
by Samson
Thanks Adrian!
When I did some of the books, I didn't know there was a tutorial for the text.
I did it a different way using the distortion tool, but I will use this method in the future.
Re: 3D relief, Mini Book
Posted: Tue Jun 12, 2018 3:49 am
by creativescrollworks
Please help a newbie to improve on this.
Used a 30 degree bit.
Re: 3D relief, Mini Book
Posted: Tue Jun 12, 2018 2:44 pm
by Mike-S
It looks like you set Z zero for the 30 deg V-bit too low. Since the entire top surface of the material gets removed when carving the book shape, what are you using as a Z touch off height?
Re: 3D relief, Mini Book
Posted: Tue Jun 12, 2018 3:59 pm
by Jozua
You need to set the Z-zero of your 30 deg V bit at exactly the same spot as you did for the 2.5D model (Book).
For the text, by selecting “Projecting toolpath onto 3D Model” the software will know where and how deep to cut your text.
Re: 3D relief, Mini Book
Posted: Wed Jun 13, 2018 2:06 am
by creativescrollworks
I used a Touch plate to set the Z point. However, I rested it on the 'UNCUT' portion of the wood, should I set it on the cut part of the book?
I did select “Projecting toolpath onto 3D Model”.
Thx for the assist.
Re: 3D relief, Mini Book
Posted: Wed Jun 13, 2018 7:02 pm
by Samson
Your Z zero should always be set from the same point. If you utilize a touch plate, do it for every bit change.
If you utilize the surface of the material, use the same UN-CUT spot for every bit change.
The point to setting the Z zero is so that every time a bit is changed, the software knows where the zero is at, so it cuts the correct depth with each bit.
Re: 3D relief, Mini Book
Posted: Wed Jun 13, 2018 8:20 pm
by Jozua
Samson wrote:The point to setting the Z zero is so that every time a bit is changed, the software knows where the zero is at, so it cuts the correct depth with each bit.
Samson, Well said!
Joz
Re: 3D relief, Mini Book
Posted: Thu Jun 14, 2018 1:47 am
by martin54