Page 1 of 1
Modify material position
Posted: Fri Jan 26, 2018 3:34 pm
by cingolo
Good afternoon
How can I change the position of the model in the workipiece once the project has been created?
I do delete all and restart?
thanks
Re: Modify material position
Posted: Fri Jan 26, 2018 4:24 pm
by joeporter
Double click on the model and you will see a set of "Handles" grab the center one and move the model where you want it. You can also resize the model up or down with the upper left handle and hold "Shift" and stretch or shrink...joe
Re: Modify material position
Posted: Fri Jan 26, 2018 4:42 pm
by Adrian
If you want to move it precisely you can also press the M key and enter absolute or relative co-ordinates.
Re: Modify material position
Posted: Sat Jan 27, 2018 12:58 pm
by cingolo
thank you at all
the last question; if I want to move on Z axis?
see image
thanks
Re: Modify material position
Posted: Sat Jan 27, 2018 2:00 pm
by Adrian
Z is basically the thickness of the part. You can't do undercuts so you can't have a piece off the base.
Re: Modify material position
Posted: Sat Feb 03, 2018 6:16 pm
by cingolo
Thank you at all!