Page 1 of 1

VCarve Patterns for making carved trim moldings

Posted: Sun Jan 07, 2018 4:03 pm
by Fleming
In researching and designing for an upcoming furniture making project I re-created these historical patterns for making moldings. All the patterns are "repeatable" so you can make them any length you want. You can download the files from my dropbox account if you wish.

https://www.dropbox.com/sh/xhn2wov3on9u ... TZ2ta?dl=0
Trim Patterns
Trim Patterns
Happy Carving!

Paul

Re: VCarve Patterns for making carved trim moldings

Posted: Sun Jan 07, 2018 4:27 pm
by joeporter
Thanks, Paul. These are very nice, just what I was looking for myself. Will wind up on a blanket chest project I have planned. Thanks again....joe

Re: VCarve Patterns for making carved trim moldings

Posted: Sun Jan 07, 2018 5:11 pm
by highpockets
Thanks Paul for sharing. Great work, I know these will make their way into some of my projects.

Re: VCarve Patterns for making carved trim moldings

Posted: Sun Jan 07, 2018 5:40 pm
by scottp55
Thanks for the files Paul!
I'm sure they'll be used:)
scott

Re: VCarve Patterns for making carved trim moldings

Posted: Sun Jan 07, 2018 11:16 pm
by Craig Thompson
Thanks you Paul. I'm sure I can use them. Thanks again.

Craig :D

Re: VCarve Patterns for making carved trim moldings

Posted: Mon Jan 08, 2018 1:44 am
by Bob Reda
Thank you Paul, very nice work

Bob

Re: VCarve Patterns for making carved trim moldings

Posted: Tue Jan 16, 2018 5:23 pm
by beone
Thanks

Dave

Re: VCarve Patterns for making carved trim moldings

Posted: Tue Jan 16, 2018 6:13 pm
by vgraves
Thanks for the files.

Re: VCarve Patterns for making carved trim moldings

Posted: Tue Jan 16, 2018 10:36 pm
by Samson
Those look nice. Can you save them for use in V8.5?
I, as well as others I'm sure, are unable to use these, since they are saved in V9.
I would appreciate it, if it's possible.

Re: VCarve Patterns for making carved trim moldings

Posted: Tue Jan 16, 2018 11:52 pm
by Fleming
Samson,

I am not able to save as an "older" version but I have uploaded both a pdf and dxf of the vectors to that dropbox folder which you should be able to import into your software. Hope this helps. If that doesn't work let me know and we can try something else.

Paul