Page 1 of 1
tappering the curved wall of a bowl on the z axis
Posted: Tue Oct 24, 2017 3:54 pm
by anyducks
Been away for a while. I have been trying to cut a bowl with curved sides on the z axis.
Can I do this with the pocket to curve the sides on the z axis?
Do I need to use the tapper ?
Thanks
Re: tappering the curved wall of a bowl on the z axis
Posted: Tue Oct 24, 2017 4:44 pm
by mtylerfl
Have you kept current with the most recent versions of the software? (What version are you using?)
Answers can vary depending what version of VCarve you are using.
Re: tappering the curved wall of a bowl on the z axis
Posted: Tue Oct 24, 2017 5:05 pm
by anyducks
vcarve pro 9.009
Re: tappering the curved wall of a bowl on the z axis
Posted: Tue Oct 24, 2017 8:24 pm
by mtylerfl
Would using any of the 3D dome shapes included in your VCarve Pro 9 software clip art do what you want? You can distort/resize as you wish.
Or maybe you can use the Molding Toolpath feature or the Fluting gadget to achieve your tapered sides shape.
Re: tappering the curved wall of a bowl on the z axis
Posted: Tue Oct 24, 2017 9:05 pm
by anyducks
Tapering will work. It takes a lot lines.
Re: tappering the curved wall of a bowl on the z axis
Posted: Tue Oct 24, 2017 11:09 pm
by PaulRowntree
Can you post a sketch of the shape you are after? The approach to take might depend on the complexity.
Re: tappering the curved wall of a bowl on the z axis
Posted: Wed Oct 25, 2017 3:06 pm
by anyducks
attached is a photo of the bowl. I want to make it a two sided job .
Re: tappering the curved wall of a bowl on the z axis
Posted: Wed Oct 25, 2017 3:26 pm
by mtylerfl
I would try the Moulding Toolpath for that. One for each side.
Re: tappering the curved wall of a bowl on the z axis
Posted: Wed Oct 25, 2017 4:15 pm
by anyducks
I have not tried the molding process. Thanks for the suggestion
Re: tappering the curved wall of a bowl on the z axis
Posted: Thu Oct 26, 2017 12:40 am
by Daner
Im very impressed that that bowl can be made with Vcarve pro.
I may try a one side tool path to make a Nut dish.
Very slick.
Re: tappering the curved wall of a bowl on the z axis
Posted: Thu Oct 26, 2017 12:56 am
by mtylerfl
Vectric Guru, Michael Mezalick showed an example (quite awhile ago) of making a bowl/dish using the Molding Toolpath feature. Here is the link...
http://forum.vectric.com/viewtopic.php? ... ng#p188945