Ramping in and out
Ramping in and out
I'm sure this is a simple setting in VCARVE Pro, but I cannot for the life of me figure out how to ramp in and back out for a simple straight groove which in the middle is 7/16-inch and gradually ramps equally in and out. Can anyone help with this?
-
- Vectric Wizard
- Posts: 1701
- Joined: Sun Sep 23, 2012 12:14 pm
- Model of CNC Machine: CNC Shark Pro, Probotix Meteor 25" x 50"
Re: Ramping in and out
The Fluting toolpath has an option to ramp in and then out. Should be exactly what you are looking for.
4D
4D