I am machining a component employing 2Rail Sweep then cutting out the component using the 3D Roughing Toolpath followed by the 3D Finishing Toolpath then Profile cuting our the component.
After a deal of head scratching and some sound advice from this forum I have now just cut out my first pair of components ..... and they are exactly what I require ...... my next problem is this.....
The Roughing toolpath is taking for too long because the step over, between successive cuts, is very small.
How do I edit this?
I am sure that the experts will find this a very simple task but with my limited experience I do need some assistance.
Thanks in anticipation