Inlay Technique.
Posted: Wed Jul 26, 2017 5:51 am
Greetings all. I tried several times to do an inlay and i am not successful as much as i want.
Here is my dilemma.
I want to do a Vbit inlay and have watched many of the tutorials available and still seem to be missing something.
I want to inlay a image with a 60 Degree 10 MM bit and a 3MM Endmill.
For the female the Start Depth is 0.0 and Cut Depth is 8MM (Maple)
For the Male the Start Depth is 4 and Cut Depth is 4MM (Walnut) Flipped Horizontal and about job center
When i did this the walnut wont fit into the female its grossly oversized and wont fit.
What did i do wrong and can i salvage my work? Even just the maple?
Wayne
Here is my dilemma.
I want to do a Vbit inlay and have watched many of the tutorials available and still seem to be missing something.
I want to inlay a image with a 60 Degree 10 MM bit and a 3MM Endmill.
For the female the Start Depth is 0.0 and Cut Depth is 8MM (Maple)
For the Male the Start Depth is 4 and Cut Depth is 4MM (Walnut) Flipped Horizontal and about job center
When i did this the walnut wont fit into the female its grossly oversized and wont fit.
What did i do wrong and can i salvage my work? Even just the maple?
Wayne