Page 1 of 1

3D Viewing Trick

PostPosted: Mon Jan 02, 2017 11:35 pm
by dwilli9013
Not sure if this has been covered before but I find it very useful and thought others may as well.
When viewing you model in 3d for the toolpaths if you hold down on the left mouse key and rotate in small circles it will rotate your model about the center axis slowly so you can get just the view you prefer. This was very useful to me in Solidworks modeling and I was very pleased to see Vectric had the same ability.

That's all I got. Thanks for all the other tips forum members have shared. Part of what makes this such an amazing forum.