Hi, when setting out a job that includes a date I often want to put in the date as the 1st or 22nd ect. now some software reduces the size and position of the "st" "nd to the upper right corner of the date number, is there any way to to this in V-carve? because if there is I can't find it and it is a right fiddle to do as a separate line entry in smaller text.
Thanks for any help.
Text sizing for dates ect.
-
- Vectric Wizard
- Posts: 1129
- Joined: Thu Jul 18, 2013 4:58 pm
- Model of CNC Machine: homebuild / VCP 8.0
Re: Text sizing for dates ect.
may not understand your question but you can convert the text to curves and select the "st" "nd" and set to what ever size you wish and position where you wish
- Adrian
- Vectric Archimage
- Posts: 14650
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Text sizing for dates ect.
VCarve has no superscript/subscript setting for fonts so DIY is the only way in the way Glenn describes.
-
- Posts: 10
- Joined: Wed Jan 27, 2016 11:24 am
- Model of CNC Machine: RYE Quantum maxi
- Location: Oxfordshire UK
- Contact:
Re: Text sizing for dates ect.
Yes that's what I've been doing Glenn but it's a fiddle especially when wrapping round curves and then changing spacings to even things up.glenninvb wrote:may not understand your question but you can convert the text to curves and select the "st" "nd" and set to what ever size you wish and position where you wish
-
- Posts: 10
- Joined: Wed Jan 27, 2016 11:24 am
- Model of CNC Machine: RYE Quantum maxi
- Location: Oxfordshire UK
- Contact:
Re: Text sizing for dates ect.
Oh well at least I haven't been missing anything obvious then!Adrian wrote:VCarve has no superscript/subscript setting for fonts so DIY is the only way in the way Glenn describes.