need Help figuring out how to carve like the picture
need Help figuring out how to carve like the picture
I need help to figure out how to carve this that it tappers to a point in the middle. Thank you in advance.
- IslaWW
- Vectric Wizard
- Posts: 1402
- Joined: Wed Nov 21, 2007 11:42 pm
- Model of CNC Machine: CNC Controller Upgrades
- Location: Bergland, MI, USA
Re: need Help figuring out how to carve like the picture
Take a look at the prism toolpath options. Adjust parameters and look over preview until desired results are achieved
Gary Campbell
GCnC Control
ATC & Servo Controller Controller Upgrades
GCnC411 (at) gmail.com
GCnC Control
ATC & Servo Controller Controller Upgrades
GCnC411 (at) gmail.com
Re: need Help figuring out how to carve like the picture
Thank you, it worked.