1 file multiple cuts
1 file multiple cuts
I have a cut file that has a foot print of 7x8 inches. I want to cut this file multiple times on a 25"x46" sheet. For the life of me I can not remember the way to step these files over, other then to copy the crv file in a new dwg and make a toolpath of the whole thing. Not bad but the next piece of scrap may a different length and I would have to do it again.
- Rcnewcomb
- Vectric Archimage
- Posts: 5928
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: 1 file multiple cuts
Since you have a ShopBot you can use a feature of the control software "Temporary Zero Points When Cutting Files "
Look in your manual on about page 18. You can also look at the manual online here: ->ShopBot User's Guide
Look in your manual on about page 18. You can also look at the manual online here: ->ShopBot User's Guide
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop
Re: 1 file multiple cuts
Thanks Randell that is what I was looking for, I knew it was out there somewhere but I keep think of 'Tiling'