This forum is for users to post tips and tricks they have found useful while working with VCarve Pro
-
Rcnewcomb
- Vectric Archimage
- Posts: 5919
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
-
Contact:
Post
by Rcnewcomb »
If you are getting the orange peel effect as shown below is means the humidity is too high. Choose a dry day for finishing
-
Attachments
-
- Orange peel because the humidity is too high
-
Bob Reda
- Vectric Wizard
- Posts: 861
- Joined: Wed Aug 16, 2006 7:34 pm
- Model of CNC Machine: shopbot 48x48 upgraded prt
- Location: Monessen, Pa
-
Contact:
Post
by Bob Reda »
You can also put in a retarder to the finish to make it dry slower
-
Bob Reda
- Vectric Wizard
- Posts: 861
- Joined: Wed Aug 16, 2006 7:34 pm
- Model of CNC Machine: shopbot 48x48 upgraded prt
- Location: Monessen, Pa
-
Contact:
Post
by Bob Reda »
You can also put in a retarder to the finish to make it dry slower
-
dmidkiff
- Vectric Apprentice
- Posts: 79
- Joined: Sat May 13, 2006 1:10 pm
- Model of CNC Machine: 2010 Shop Bot PRS Alpha 18"Z
- Location: Jasper, TX
-
Contact:
Post
by dmidkiff »
Try spraying with retarder only to even out.
Dave