Leo wrote:When you say you "probe" the bits to a line. Please elaborate on that, in detail. Do you have a tool touch probe? Is it possibly moving?
VE5MDH wrote:Leo wrote:At what point did the warping of the wood occur?
Leo wrote:VE5MDH wrote:Leo wrote:At what point did the warping of the wood occur?
Ahhh yes of course. Anytime you cut out a pocket and remove a large percentage of wood from one side and not the other side, warping can be an issue.
Sooo, when you touch off the tool, do you use a piece of paper, or a shim, by eye, or do you just touch to the wood?
Users browsing this forum: No registered users and 4 guests