first box w/ new dove tail technique
-
- Vectric Apprentice
- Posts: 81
- Joined: Fri May 19, 2006 8:30 pm
first box w/ new dove tail technique
This is my first little project with my dove tail joining technique its a plain pine box (urn} with maple top no finish yet. no nails just dab of glue in corners. it gets a brass label and that all.
Re: first box w/ new dove tail technique
Very nice work John. Please post a picture when the finishing is done.
Cobblewood Carver
- Greasetattoo
- Vectric Wizard
- Posts: 854
- Joined: Sat Mar 24, 2007 3:14 pm
- Location: Saint Paul, Minnesota
- Contact:
Re: first box w/ new dove tail technique
Nice box, that is on my list..
I have to make a urn.
How did you do the dovetails?
Cnc or by hand?
Jig?
I have to make a urn.
How did you do the dovetails?
Cnc or by hand?
Jig?
-
- Vectric Apprentice
- Posts: 81
- Joined: Fri May 19, 2006 8:30 pm
Re: first box w/ new dove tail technique
they were done on cnc i started a thread a few days ago i have modified the tool paths several times since then, i will post them again later trial and error about done for me.?
- Greasetattoo
- Vectric Wizard
- Posts: 854
- Joined: Sat Mar 24, 2007 3:14 pm
- Location: Saint Paul, Minnesota
- Contact:
Re: first box w/ new dove tail technique
Do you think it was worth the extra effort?
Rather, then just using a jig and router?
Please post your modified toolpaths..
thanks
Rather, then just using a jig and router?
Please post your modified toolpaths..
thanks