first box w/ new dove tail technique

This is the place to post images of work produced using Aspire
Post Reply
john teichman
Vectric Apprentice
Posts: 81
Joined: Fri May 19, 2006 8:30 pm

first box w/ new dove tail technique

Post by john teichman »

This is my first little project with my dove tail joining technique its a plain pine box (urn} with maple top no finish yet. no nails just dab of glue in corners. it gets a brass label and that all.
Attachments
winter 08 around christmas 568.jpg
winter 08 around christmas 567.jpg
winter 08 around christmas 570.jpg

Fleming
Vectric Wizard
Posts: 400
Joined: Tue Oct 28, 2008 3:41 pm

Re: first box w/ new dove tail technique

Post by Fleming »

Very nice work John. Please post a picture when the finishing is done.
Cobblewood Carver

User avatar
Greasetattoo
Vectric Wizard
Posts: 854
Joined: Sat Mar 24, 2007 3:14 pm
Location: Saint Paul, Minnesota
Contact:

Re: first box w/ new dove tail technique

Post by Greasetattoo »

Nice box, that is on my list..
I have to make a urn.

How did you do the dovetails?
Cnc or by hand?
Jig?

john teichman
Vectric Apprentice
Posts: 81
Joined: Fri May 19, 2006 8:30 pm

Re: first box w/ new dove tail technique

Post by john teichman »

they were done on cnc i started a thread a few days ago i have modified the tool paths several times since then, i will post them again later trial and error about done for me.?

User avatar
Greasetattoo
Vectric Wizard
Posts: 854
Joined: Sat Mar 24, 2007 3:14 pm
Location: Saint Paul, Minnesota
Contact:

Re: first box w/ new dove tail technique

Post by Greasetattoo »

Do you think it was worth the extra effort?
Rather, then just using a jig and router?

Please post your modified toolpaths..
thanks

Post Reply