LightHouse

[TReischl]

Hope nobody minds that I do not post machined images, but my machine is in storage while our house is being built, which is a whole other story. Meanwhile, I am taking the time, while I sit in this apartment drooling over the stuff you folks are cutting on your machines, trying to really learn Aspire.

Over in the Tips and Tricks I posted about creating towers and walls, here is something I created using the technique. I can't wait to cut it when my machine is up and running again.

[Greasetattoo]

Very cool..

You did a GREAT job on that lighthouse..

Now, how about some waves, background...

I am very impressed...

[wrench]

Very nice. You guys are getting good!

Shawn

[Phil]

I can almost hear the ships crashing against the rocks. Where are the lights?

[joecnc2006]

Looks really good, That would make a really nice component.

Joe

[Thkoutsidthebox]

Very Nice!! The wall technique really came up trumps.

[TReischl]

Since I had the lighthouse, well, I needed a house for the keeper. So here it is. I built a complete house and then used the bitmamp tracing to cut the hole thru the middle to place the lighthouse. Like I said before, the tools in Aspire are really amazing and easy to use, the key to doing this is getting your drawings organized. Hope everyone is enjoying this!

[Turtle49]

Nice Ted!

You might consider putting a couple of brick "patches" on the end wall. Just a thought...

Tim

[Greasetattoo]

Sweet!

Very nice work!

Now, how about some light shining through and a little smoke coming from the smoke stack on top of the house?

Looks fantastic!

How many hours you figure???

[Marwellca]

It just keeps getting better and better.

Martyn.