I cut the deer scene last night and this morning.
It's 11in tall and 8in wide cut into a 1.75 thick slab of cherry. I used a strait 2flute .25 bit to rough that took 2hrs. I then used an .125 rotozip saber bit for the finish pass set at 6% stepover @ 50ipm but watching the DRO it never got above about 30.and that took a HOLE!@!#!%$!#% OF time 10 hrs total there were over 300,000 lines of code.
I had to stop the router last night at 11pm because i didn't want it to run while I was asleep...........
I restarted it at 6am and finished..................................
Any one have any hints or tricks to make this go a little quicker? That scene does have alot of details.
Thanks,
Nick
Deer Scene
- joecnc2006
- Vectric Wizard
- Posts: 351
- Joined: Sun Sep 03, 2006 6:32 pm
- Location: Marion, Texas
Re: Deer Scene
I did the same thing Saturday, here was my results and some suggestions to speed it up.
http://www.vectric.com/forum/viewtopic.php?f=29&t=4027
Joe
http://www.vectric.com/forum/viewtopic.php?f=29&t=4027
Joe
Thanks,
Joe
http://www.joescnc.com
Joe
http://www.joescnc.com