These are grips for a S&W .45 commander, pro series. I made two sets, one for mine and one for my wife's.
They are walnut and maple. I cut the inlay shape and a pocket for it in the walnut. Then I glued the inlay blank into the pocket. So the 3D inlay was cut at the same time as the shape of grip. The slants on the bottom were done with a 45 degree v carve bit. They are raised above the surface about .030 around the edges.
Happy Dog Grips (45)
- TReischl
- Vectric Wizard
- Posts: 4653
- Joined: Thu Jan 18, 2007 6:04 pm
- Model of CNC Machine: 8020 48X36X7 RP 2022 UCCNC Screenset
- Location: Leland NC
Happy Dog Grips (45)
"If you see a good fight, get in it." Dr. Vernon Johns
-
- Vectric Wizard
- Posts: 409
- Joined: Thu Apr 06, 2017 3:07 am
- Model of CNC Machine: Camaster Stinger SR24
- Location: Addison, PA
Re: Happy Dog Grips (45)
Awesome grips for an awesome pistol. Very well done!
Joe
I have a chip on my shoulder....several more in my hair and lots more all over my shop floor.
I have a chip on my shoulder....several more in my hair and lots more all over my shop floor.
-
- Vectric Wizard
- Posts: 1479
- Joined: Sun Nov 28, 2010 5:10 pm
- Model of CNC Machine: Home built designs - 3'x4' and 5'x12'
- Location: Eastern NC, USA
Re: Happy Dog Grips (45)
I have to ask Ted, does the dog bite when it jumps at you?
Very nice work and looks very good.
CarveOne
Very nice work and looks very good.
CarveOne
CarveOne
http://www.carveonecncwoodcraft.com
http://www.carveonecncwoodcraft.com
- mtylerfl
- Vectric Archimage
- Posts: 5892
- Joined: Thu Jan 29, 2009 3:54 am
- Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
- Location: Brunswick, GA
Re: Happy Dog Grips (45)
Well done, Ted!!
Michael Tyler
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC