first ever job

This is the place to post images of work produced using Aspire

first ever job

Postby MTLCHSR » Thu Jul 11, 2019 6:02 am

This is my first use of the Vectric software. As well as the router (Vertigo M2) for that matter. Had never done a job prior... and customer wanted this done to finish off the bike. - no pressure ! :wink: Custom made chopper bike housing. T6 Aircraft ali. Just drew the part in Aspire. Followed the chart with the tool and path settings... watched the preview... looked good. Set the home and surface and away we went. (Well... I had watched a lot of the tutorials before hand so I did know a wee bit of what to expect)
Attachments
20190624_100948.jpg
MTLCHSR
 
Posts: 2
Joined: Wed May 24, 2017 10:31 pm
Location: Dannevirke New Zealand
Model of CNC Machine: Vertigo, Meistergram and Gravograph IS40

Re: first ever job

Postby gkas » Thu Jul 11, 2019 6:52 am

Nice job. It definitely set off the case quite well.
User avatar
gkas
Vectric Wizard
 
Posts: 391
Joined: Sun Jan 01, 2017 3:39 am
Location: Southern California
Model of CNC Machine: Aspire, Axiom AR8 Pro+, Axiom 4.2W Laser

Re: first ever job

Postby scottp55 » Thu Jul 11, 2019 10:26 pm

CONGRATS!!! :)
Hope the word gets around!
scott
scott
User avatar
scottp55
Vectric Wizard
 
Posts: 2905
Joined: Thu May 09, 2013 11:30 am
Location: Kennebunkport, Maine, US
Model of CNC Machine: ShopbotDesktop 5.5"Z/spindle/VCP9.5

Re: first ever job

Postby ezurick » Fri Jul 12, 2019 10:27 am

MTLCHSR wrote:This is my first use of the Vectric software. As well as the router (Vertigo M2) for that matter. Had never done a job prior... and customer wanted this done to finish off the bike. - no pressure ! :wink: Custom made chopper bike housing. T6 Aircraft ali. Just drew the part in Aspire. Followed the chart with the tool and path settings... watched the preview... looked good. Set the home and surface and away we went. (Well... I had watched a lot of the tutorials before hand so I did know a wee bit of what to expect)



Very nice indeed. What tool did you use? ali = aluminum?

I remember many years ago (around 2002 timeframe) I really wanted to get into CNC. But the lack of support and videos really turned me off at that time. Of course I was a musician and got into building my recording studio instead. But my point is that unlike today, there wasn't much for support back then, unless you were a big business with a big budget... lol.
User avatar
ezurick
Vectric Craftsman
 
Posts: 179
Joined: Sat Oct 20, 2018 1:27 pm
Model of CNC Machine: Chinese 6040


Return to Aspire - Gallery

Who is online

Users browsing this forum: No registered users and 15 guests