Page 1 of 1

Great Horned Owl

PostPosted: Tue Jun 11, 2019 7:50 pm
by mark-s
Great Horned Owl.
3 inch tall X 1- 3/16 inch wide.
Maple, clear coat.
Maple carves so nice and clean.
mark-s

CNC GREAT HORNED OWL 8.jpg

Re: Great Horned Owl

PostPosted: Tue Jun 11, 2019 8:37 pm
by mtylerfl
I Like it!

Re: Great Horned Owl

PostPosted: Wed Jun 12, 2019 10:50 am
by scottp55
NICE clean cut Tiny piece Mark!! :)
Gotta look for that model:)
scott

Re: Great Horned Owl

PostPosted: Wed Jun 12, 2019 9:48 pm
by Creation in Wood
I like the Great Horned Owl.
Where did you get the model? I would like to cut a bigger one.

Re: Great Horned Owl

PostPosted: Thu Jun 13, 2019 12:17 pm
by bravesoul
I found some similar STL's (I think) here: https://www.yeggi.com/q/great+horned+owl/

Re: Great Horned Owl

PostPosted: Wed Jun 19, 2019 1:33 am
by TReischl
bravesoul wrote:I found some similar STL's (I think) here: https://www.yeggi.com/q/great+horned+owl/


Gotta be careful shopping STL files. A lot of them are full in the round 3D. Those are difficult to work with usually. Well, that has been my experience anyhow.