CNC made bench and chair
-
- Vectric Apprentice
- Posts: 68
- Joined: Sat Sep 17, 2016 1:56 am
- Model of CNC Machine: PDJ pilot pro
- Location: Calgary Alberta
CNC made bench and chair
I used a corner chisel to square up the corners of the finger joint. I cut the left side first, and found it was a bit too tight, so I widened the joint by 0.001 on each side, and it fit perfectly.
I will modify the chair seat contour. The ridge in the middle is fine if you are sitting up perfectly straight, but becomes a bit...intrusive if you slide forward at all in your seat. The ridge in the bench is much more comfortable.
I cut all the parts on my CNC, and used my Aurio rasps (fantastic tools!) to do some profiling.
-
- Vectric Craftsman
- Posts: 155
- Joined: Wed May 09, 2007 9:27 pm
- Model of CNC Machine: Shopbot
- Location: Austin, Texas
- Contact:
Re: CNC made bench and chair
Nice designs. Nice seat. I like the bench seat with the bottom profile.
Re: CNC made bench and chair
Nice work. I like the artistic design, very eye catching.
- Creation in Wood
- Vectric Wizard
- Posts: 856
- Joined: Thu May 28, 2015 8:58 pm
- Model of CNC Machine: Legacy Maverick ATC 4x8 CNC
- Location: Monument, Colorado USA