Page 2 of 2
Re: a simple bowl with a mapped model
Posted: Thu Feb 14, 2019 2:18 am
by TReischl
Len-Tikular wrote:Thanks all, I had my material setup, set incorrectly. It was 6mm below the surface of the material.
Interestingly enough I do not have zero plane insert in Aspire 4.5
Thanks
George
There is a zero plane insert in Aspire 4.5 in the Model Menu at the top of the screen.
Model/Add Zero Plane
Definitely there, since I run 4.5 every day.
Re: a simple bowl with a mapped model
Posted: Sat Feb 16, 2019 1:02 am
by Len-Tikular
Jobs all done and dusted Martin, thanks all for the help. Looking good if I must say so!
George
Re: a simple bowl with a mapped model
Posted: Sat Feb 16, 2019 11:40 am
by martin54
Re: a simple bowl with a mapped model
Posted: Mon Feb 18, 2019 7:26 pm
by Len-Tikular
Good call Martin,
Not a very good picture but here it is,
Regards
George
