Beer Tap project

This is the place to post images of work produced using Aspire

Beer Tap project

Postby dseaver » Wed Oct 10, 2018 4:07 pm

The attached two photos shows the finished beer taps made for a startup brewery. The tap handles were CNC cut using walnut and red oak. After the handles were cut out they were sanded and treated with rub on poly to seal the wood. The handles were then masked with Oramask 813 and all graphics and lettering were laser cut at a depth of .075. The laser cut graphics and lettering were sealed with poly to prevent bleeding. The next step was 3 coats of black acrylic paint applied via air brush. Th e mask was removed and the taps were sanded with 600 grit sand paper between each of 3 coats of lacquer.


tap project.jpg
dseaver
 
Posts: 4
Joined: Fri Sep 04, 2009 2:03 pm

Re: Beer Tap project

Postby bolingerbe » Thu Oct 11, 2018 1:01 am

Great Job
bolingerbe
 
Posts: 42
Joined: Tue Mar 16, 2010 1:38 am
Model of CNC Machine: MechMate

Re: Beer Tap project

Postby mtylerfl » Thu Oct 11, 2018 3:09 am

Yes, great job! I like the v-carved hops design!
Michael Tyler

carvebuddy.com

facebook.com/carvebuddy

-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
User avatar
mtylerfl
Vectric Wizard
 
Posts: 3284
Joined: Thu Jan 29, 2009 3:54 am
Location: Brunswick, GA
Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha

Re: Beer Tap project

Postby Creation in Wood » Tue Oct 30, 2018 6:04 pm

Nice work
Thank You
Doug
User avatar
Creation in Wood
Vectric Wizard
 
Posts: 372
Joined: Thu May 28, 2015 8:58 pm
Location: Monument, Colorado USA
Model of CNC Machine: Legacy Maverick CNC 4x8


Return to Aspire - Gallery

Who is online

Users browsing this forum: GaryR6, sseale and 10 guests