Beer Tap project

This is the place to post images of work produced using Aspire

Beer Tap project

Postby dseaver » Wed Oct 10, 2018 4:07 pm

The attached two photos shows the finished beer taps made for a startup brewery. The tap handles were CNC cut using walnut and red oak. After the handles were cut out they were sanded and treated with rub on poly to seal the wood. The handles were then masked with Oramask 813 and all graphics and lettering were laser cut at a depth of .075. The laser cut graphics and lettering were sealed with poly to prevent bleeding. The next step was 3 coats of black acrylic paint applied via air brush. Th e mask was removed and the taps were sanded with 600 grit sand paper between each of 3 coats of lacquer.

tap project.jpg
Posts: 5
Joined: Fri Sep 04, 2009 2:03 pm
Location: Troy, New York
Model of CNC Machine: Camaster Stinger 2 4 by 4

Re: Beer Tap project

Postby bolingerbe » Thu Oct 11, 2018 1:01 am

Great Job
Posts: 44
Joined: Tue Mar 16, 2010 1:38 am
Model of CNC Machine: MechMate

Re: Beer Tap project

Postby mtylerfl » Thu Oct 11, 2018 3:09 am

Yes, great job! I like the v-carved hops design!
Michael Tyler

-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
User avatar
Vectric Wizard
Posts: 3766
Joined: Thu Jan 29, 2009 3:54 am
Location: Brunswick, GA
Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha

Re: Beer Tap project

Postby Creation in Wood » Tue Oct 30, 2018 6:04 pm

Nice work
Thank You
User avatar
Creation in Wood
Vectric Wizard
Posts: 420
Joined: Thu May 28, 2015 8:58 pm
Location: Monument, Colorado USA
Model of CNC Machine: Legacy Maverick CNC 4x8

Return to Aspire - Gallery

Who is online

Users browsing this forum: No registered users and 10 guests