Page 1 of 1
Gryphon in Poplar
Posted: Mon Aug 13, 2018 1:56 am
by Rcnewcomb
Gryphon in Home Depot Poplar. Machine time: 110 minutes with a 1/8" ballnose @9% stepover
Re: Gryphon in Poplar
Posted: Mon Aug 13, 2018 2:12 am
by mark-s
Very Nice, Like it alot.
mark-s
Re: Gryphon in Poplar
Posted: Mon Aug 13, 2018 8:03 am
by LittleGreyMan
Very clean cut, especially in a soft wood.
Is it out of the machine or did you sand it?
Re: Gryphon in Poplar
Posted: Mon Aug 13, 2018 3:43 pm
by Rcnewcomb
Is it out of the machine or did you sand it?
I did about 2 minutes of sanding to knock the fuzzies off. Wish I could remember where I bought the 1/8" ball nose bit. It might be a Hertel.
Re: Gryphon in Poplar
Posted: Mon Aug 13, 2018 5:30 pm
by GeneMpls
Very nice Randall- I did the same gryphon in Corian this weekend- my first carve with my new [to me] BT48 alpha.
Re: Gryphon in Poplar
Posted: Mon Aug 13, 2018 6:59 pm
by mark-s
Rcnewcomb how deep was that cut?
Thanks
mark-s
Re: Gryphon in Poplar
Posted: Mon Aug 13, 2018 7:49 pm
by Rcnewcomb
Rcnewcomb how deep was that cut?
Just under 0.4" so I was able to use a bit with 1/2" cutting length with no roughing pass.
Re: Gryphon in Poplar
Posted: Sat Aug 18, 2018 8:09 pm
by Makingtoothpicks
The Gryphon model is that an Aspire model or Design and Make
Don
Re: Gryphon in Poplar
Posted: Sat Aug 18, 2018 8:21 pm
by highpockets
Aspire, Gryphon-57616-A.3dClip
Re: Gryphon in Poplar
Posted: Sun Aug 19, 2018 10:13 pm
by Creation in Wood
Very nice